dopalodge.blogg.se - Reset aeon labs z-stick

Reset aeon labs z stick install#
Reset aeon labs z stick software#

Remove the device from OH Inbox if needed.

In the “Device Management” Section it should state Device # “ID” as excluded.

Now you should be able to select the Node ID at the top of the “Network Maintenance” Section and click on “Remove failed Node”.

Choose again your dead nod and click again on “Mark Battery Device as failed”.wait 30 sec as stated until the job is done.In the Network Maintenance Section s elect your device Node ID and click “ Mark Battery Device as failed”.Hover on “Network” and klick on “Control”.Go into ExpertGui Mode and follow the folloing steps:.

Reset aeon labs z stick install#

Start zway-service (go to install locateion and type “./z-way-server”).

But I recommend to at least remove the thing)

(In OH set device as failed and remove it, maybe this step is not needed.

Install zway server (something like -dpkg -x z-way-3.2.0_b “folder-location”–.

To make it clear for everyone who is struggling, here is the detailed procedure: I finally managed to remove the devices using z-way-server (on RPi 3+, openhabian and raZberry/ controller. I’m running openHAB2 v2.5 on a Raspberry Pi 4. So is there working solution or work around for this problem? Then I deleted the xml files which where generated during inclusion of the “ghost” nodes from the /Zwave folder.īut every time I’m searching for new ZWave things the “ghost” nodes I thought that were deleted appear again.

Enabled “Remove device from controller”.

Set the “ghost” node into editing mode again.

I tried the binding to delete it from the ZWave USB stick byĪs I read in certain threads the ZWave USB stick will only remove failed I hoped that this marked the “ghost” node as failed in the ZWave USB stick’s internal database.

And starting the exclusion to my mind will delete the door lock instead of the ghost knodes.

Reset aeon labs z stick software#

The software asks me to initialize the exclusion procedure by pressing the button - which is impossible because I included the door lock successfully. These ghost nodes were generated BEFORE successful inclusion of the door lock.īecause I’m running a linux system, I tried to use the ZWave tools “ZenSys” and “HS3” in a virtual machine and tried to delete the ghost nodes. After I added the “ABUS Z-Wave HomeTec CFA3010” door lock to the Z-Wave database - thanks to Chris, Bruce and suhui - I have to remove two “ghost” nodes (nodes 10 and 11) from my Aeotec Z-Wave USB stick.